מאפייני הסחורה

Item Type:

Depth Gauge

Material:

Stainless Steel 316L + Anti-Fog Glass

Installation Diameter:

Approx. Φ52mm/2in

Depth Indication Range:

Approx. 100m/110yd

Backlight Color:

White

Working Voltage:

9-32VDC

Working Current:

≤100mA

Working Tempe ure:

-30℃ to +75℃

Storage Tempe ure:

-40℃ to +85℃

Protection Grade:

IP67, the back cover is IP5

Ope ion:

A. This device is work with 12V system only, to indicate the depth appointed. Normally, the buzzer beeps once when it was connected correctly then turn on the power.:

B. Keypad Mode:

Quick press the keypad Mode to switch SH/DP/KL/ UN Hold the keypad Mode to turn on/off the monitor. Short press the keypad “▲“▼to set the value required. Hold the keypad “▲”“▼to keep the digital increasing/decreasing fluently.

Parameter:

SH

Range:

1. Unit “M”:

0-99

2. Unit “FT:

0-199

3. Unit “F”:

0-49 If the level exceed the a pointed value , the buzzer will beeps twice Keel offset (KL)

Range:

1. Unit“M”:

0-6.0

2. Unit“FT:

0-19.9

3. Unit“F”:

0-3.3

Installation Notes:

1. Make a 52mm/2in diameter hole on the panel of your cabin panel and instrument panel, insert the instrument into the hole. The panel corresponding to the instrument panel is marked with a boss, and make a small notch at this position to ensure that there is at least 52mm/2in of the instrument panel on the back of the instrument.:

2. After installing the instrument into the panel, screw it down with the fixing ring.:

3. Connect the wires and connect the instrument case directly to the 12/24V power supply.: